PolyBonda / Application
Adhesive layers and material considerations for lined metal parts.
Application snapshot
Adhesive layers and material considerations for lined metal parts.
substrate and geometry · contents and exposure · surface preparation
pipe or tank geometry · substrate information · contents and service conditions
Start with the part, then review relevant material information.
Connect material selection to the substrate, geometry and contents of the lined part. SG-38A is an adhesive-layer material for PE tie layers and corrosion-protection rotolining of pipes and tanks. Discuss surface preparation, bonding and processing requirements for your application.
Application discussion
Describe this requirement in the context of the finished part and intended use.
Describe this requirement in the context of the finished part and intended use.
Describe this requirement in the context of the finished part and intended use.
Describe this requirement in the context of the finished part and intended use.
What to share with us
You do not need every answer before starting a discussion. The information below helps focus the next material questions.
